Mazda B-Series 1998-06

Relieving Fuel System Pressure

Print

All multi-port fuel injected engines are equipped with a pressure relief valve located on the fuel supply manifold. Remove the fuel tank cap and attach fuel pressure gauge T80L-9974-B, or equivalent, to the valve to release the fuel pressure. Be sure to drain the fuel into a suitable container and to avoid gasoline spillage. If a pressure gauge is not available, disconnect the vacuum hose from the fuel pressure regulator and attach a hand-held vacuum pump. Apply about 25 in. Hg (84 kPa) of vacuum to the regulator to vent the fuel system pressure into the fuel tank through the fuel return hose. Note that this procedure will remove the fuel pressure from the lines, but not the fuel. Take precautions to avoid the risk of fire and use clean rags to soak up any spilled fuel when the lines are disconnected.

An alternate method of relieving the fuel system pressure involves disconnecting the inertia switch. Follow the procedures outlined later in this Section.



Click image to see an enlarged view

Fig. The fuel pressure relief valve (A) is located on the fuel supply manifold

All Sequential Fuel Injection (SFI) fuel injected engines are equipped with a pressure relief valve located on the fuel supply manifold. Remove the fuel tank cap and attach fuel pressure gauge T80L-9974-B, to the valve to release the fuel pressure. Be sure to drain the fuel into a suitable container and to avoid gasoline spillage. If a pressure gauge is not available, disconnect the vacuum hose from the fuel pressure regulator and attach a hand-held vacuum pump. Apply about 25 in. Hg (84 kPa) of vacuum to the regulator to vent the fuel system pressure into the fuel tank through the fuel return hose. Note that this procedure will remove the fuel pressure from the lines, but not the fuel. Take precautions to avoid the risk of fire and use clean rags to soak up any spilled fuel when the lines are disconnected.

An alternate method of relieving the fuel system pressure involves disconnecting the inertia switch.

 
label.common.footer.alt.autozoneLogo