Mazda MPV 1999-06

Door Glass & Regulator

Print

Power Windows



Diagnosis & Testing

If all power windows are inoperative, inspect the following:



Wiring, connectors and circuitry
 
Accessory delay relay
 
Driver window control switch
 
Smart junction box
 

If a single power window is inoperative and it is the drivers window, inspect the following:



Wiring, connectors and circuitry
 
Driver window motor
 
Driver window control switch
 

If a single power window is inoperative and it is the passenger front window, inspect the following:



Wiring, connectors and circuitry
 
Passenger front window motor
 
Passenger front window control switch
 
Driver window control switch
 

If any of the rear power windows are inoperative, inspect the following:



Wiring, connectors and circuitry
 
Rear window motor
 
Rear window control switch
 
Driver window control switch
 

If the -one touch down- feature is inoperative, inspect the driver window control switch

Removal & Installation
Motor & Regulator
Front
  1. Disconnect the negative battery cable.
  2.  
  3. Remove the front door glass.
  4.  
  5. Disconnect the front power window regulator connector.
  6.  
  7. Remove the nuts, then remove the front power window regulator.
  8.  
  9. To install, reverse removal procedure. Torque nuts to 86 inch lbs. (8 Nm).
  10.  

Rear
  1. Disconnect the negative battery cable.
  2.  
  3. Remove the rear door glass.
  4.  
  5. Disconnect the rear power window regulator connector.
  6.  
  7. Remove the nuts, then remove the rear power window regulator.
  8.  
  9. To install, reverse removal procedure. Torque nuts to 86 inch lbs. (8 Nm).
  10.  

Switch
Main
  1. Disconnect the negative battery cable.
  2.  
  3. Remove the front door trim.
  4.  
  5. Push out the clip from behind the front door trim, and remove the switch panel.
  6.  
  7. Remove the screws, and remove the power window main switch.
  8.  
  9. To install, reverse removal procedure.
  10.  

Subswitch
Passenger Side
  1. Disconnect the negative battery cable.
  2.  
  3. Remove the front door trim.
  4.  
  5. Push out the clip from behind the front door trim, and remove the switch panel.
  6.  
  7. Remove the screws, and remove the power window sub switch.
  8.  
  9. To install, reverse removal procedure.
  10.  

Rear
  1. Disconnect the negative battery cable.
  2.  
  3. Remove the hook by inserting a tape-wrapped flathead screwdriver between the switch and the rear door trim.
  4.  
  5. Disconnect the connector, and remove the power window sub switch.
  6.  
  7. To install, reverse removal procedure.
  8.  

 
label.common.footer.alt.autozoneLogo