Mazda Tribute 2001-06

2.3L L4 VIN D Std 4

Print

Trouble Code: P0602



PCM programming error

Possible Causes:



Reprogramming has not been completed properly
 
PCM has failed
 

Trouble Code: P0603



PCM Keep Alive Memory Test Error

Possible Causes:



KAM circuit is open (it may be an intermittent problem)
 
KAM circuit is shorted to ground
 
Battery terminals have high resistance due to corrosion or dirt
 
PCM has failed
 

Trouble Code: P0605



PCM Read Only Memory Test Error

Possible Causes:



PCM has failed (an internal fault)
 
PCM must be replaced when this code is set
 

Trouble Code: P0606



ECM/PCM Processor

Possible Causes:



PCM internal CPU malfunction
 

Trouble Code: P0620



Regulator / Generator malfunction

Possible Causes:



PCM internal malfunction* Configuration has not been properly completed.
 

Trouble Code: P0622



Control Module performance

Possible Causes:



PCM internal malfunction* Configuration has not been properly completed.
 

Trouble Code: P0645



A/C clutch relay (ACCR) malfunction

Possible Causes:



PCM internal malfunction* ACCR malfunction
 

Trouble Code: P0660



Variable Inertia Charging System Circuit Malfunction

Possible Causes:



VICS control circuit is open or shorted to ground
 
VICS power circuit is open (check the power from the relay)
 
VICS valve is damaged or has failed
 
PCM has failed
 

Trouble Code: P1001



Data Link Connector Circuit Malfunction

Possible Causes:



DLC connector or the related terminals/pins are damaged
 
DLC Bus (+) circuit is open or shorted to ground
 
DLC Bus (+) circuit is shorted at an associated module
 
DLC ground circuit is open or has a high resistance condition
 
PCM power relay is damaged or has failed (no power to DLC)
 
Incorrect Self-Test procedure followed, or idle speed to low
 
PCM has failed (e.g., the PCM VREF may be out-of-range)
 

Trouble Code: P1100



Mass Airflow Sensor Circuit Malfunction (Intermittent)

Possible Causes:



MAF sensor continuity problems at the connector or harness
 
MAF sensor circuit is open (the fault may be intermittent)
 
MAF sensor is damaged or has failed
 
PCM has failed
 

Trouble Code: P1101



Mass Airflow Sensor Malfunction (Self-Test)

Possible Causes:



MAF sensor is damaged, dirty or has failed
 
MAF sensor (inlet) screen is dirty or blocked
 
An intake air leak is present near the MAF sensor location
 
PCM has failed
 

Trouble Code: P1112



Intake Air Temperature Sensor Signal Circuit Malfunction

Possible Causes:



IAT sensor signal circuit is open (an intermittent fault)
 
IAT sensor signal circuit is shorted to ground (intermittent fault)
 
IAT sensor is damaged or has failed (an intermittent fault)
 
PCM has failed
 

Trouble Code: P1116



Engine Coolant Temperature Sensor Circuit Malfunction (Self-Test)

Possible Causes:



ECT sensor signal circuit open or shorted to ground
 
ECT sensor signal shorted to VREF or system power
 
ECT sensor
 

Trouble Code: P1117



Engine Coolant Temperature Sensor Circuit Malfunction

Possible Causes:



ECT sensor signal is open (an intermittent fault)
 
ECT sensor signal shorted to ground (an intermittent fault)
 
ECT sensor is damaged or has failed (an intermittent fault)
 
PCM has failed
 

Trouble Code: P1120



TP Sensor Signal Out of Range Low

Possible Causes:



TP sensor contacts are loose, broken or damaged
 
TP sensor pins are loose in the connector
 
TP sensor signal circuit shorted to ground (an intermittent fault)
 
TP sensor is damaged or has failed
 
PCM has failed
 

Trouble Code: P1121



Throttle Position Signal Not Consistent With MAF Signal

Possible Causes:



MAF sensor is damaged or has failed
 
TP sensor is damaged or has failed
 
Air leaks between the MAF sensor and the throttle body
 
PCM has failed
 

Trouble Code: P1124



Throttle Position Sensor Signal Out Of Range (Self-Test)

Possible Causes:



Throttle linkage is bent or binding
 
TP sensor is not seated properly
 
Throttle plate below closed throttle position, or throttle plate screw misadjusted
 
TP sensor is damaged
 
PCM has failed
 

Trouble Code: P1125



Throttle Position Sensor Signal Circuit Malfunction

Possible Causes:



TP sensor wiring harness is open (an intermittent fault)
 
TP sensor connector or pins are open (an intermittent fault)
 
TP sensor signal circuit is open (an intermittent fault)
 
TP sensor signal circuit is grounded (an intermittent fault)
 

Trouble Code: P1127



HO2S-12 (Bank 1 Sensor 2) Heater Not Enabled (Self-Test)

Possible Causes:



Engine not operated long enough prior to starting the KOER Self-Test
 
Exhaust system temperature is too cold to run the test
 

Trouble Code: P1130



HO2S-11 (Bank 1 Sensor 1) Fuel Control Limit Reached

Possible Causes:



HO2S is damaged or has failed
 
HO2S circuits wet or oily, corroded, or poor terminal contact
 
HO2S signal circuit open, shorted to ground, short to power
 
Low fuel pressure or vehicle driven until it was out of fuel
 
Fuel pressure regulator leaking, or fuel injectors leaking
 
EVAP vapor recovery system has failed
 
Air leaks located after the MAF sensor
 
Exhaust leaks before or near the front HO2S
 
EGR valve stuck, EGR diaphragm leaking, or gasket leaking
 
Oil dipstick not seated or engine oil level too high (overfilled)
 

Trouble Code: P1131



HO2S-11 (Bank 1 Sensor 1) Indicates A/F Ratio Too Lean

Possible Causes:



Air leaks located after the MAF sensor
 
Base Engine: Check for vacuum leaks with a Smoke Tester
 
Intake air system is leaking, obstructed and damaged
 
Low fuel pressure or vehicle driven until it was out of fuel
 
PCV system has air leaks at the valve or related hoses
 

Trouble Code: P1132



HO2S-11 (Bank 1 Sensor 1) Indicates A/F Ratio Too Lean

Possible Causes:



Air leaks located after the MAF sensor
 
Base Engine: Check for vacuum leaks with a Smoke Tester
 
Intake air system is leaking, obstructed and damaged
 
Low fuel pressure or vehicle driven until it was out of fuel
 
PCV system has air leaks at the valve or related hoses
 

Trouble Code: P1137



HO2S-12 Lack of Switching, Indicates Lean (Self-Test)

Possible Causes:



Air leaks located after the MAF sensor
 
Base Engine: Check for vacuum leaks with a Smoke Tester
 
HO2S wiring may be crossed at the connector
 
Check intake air system for leaks, obstructions and damage
 
EGR system malfunction (the EGR valve may be stuck open)
 
PCV system has air leaks at the valve or related hoses
 
Fuel pressure is too low (fuel filter is dirty, or weak fuel pump)
 
Vehicle driven until it was out of fuel
 

Trouble Code: P1138



HO2S-12 Lack of Switching, Indicates Rich (Self-Test)

Possible Causes:



Check air cleaner element, air cleaner housing for blockage
 
Fuel pressure regulator is leaking, or fuel pressure is too high
 
HO2S wiring may be crossed at the connector
 
Fuel injectors leaking or contaminated (they may be sticking)
 
EVAP vapor recovery system has failed (canister full of fuel)
 

Trouble Code: P1169



HO2S-12 (Bank 1 Sensor 2) Circuit No Inversion

Possible Causes:



An air leak that is located after the MAF sensor
 
Base engine mechanical fault affecting one or more cylinders
 
EVAP Purge valve stuck or the hoses to the valve are reversed
 
Fuel metering fault (fuel injector sticking open or leaking)
 
Fuel pressure too low or too high, fuel supply contaminated
 
HO2S element is contaminated or the HO2S heater has failed
 
PCV system has air leaks at the valve or related hoses
 

Trouble Code: P1233



Fuel Pump Control Circuit Malfunction

Possible Causes:



Fuel pump relay control circuit is open
 
Fuel pump relay control circuit is shorted to ground
 
Fuel pump relay power circuit is open
 
PCM has failed
 

Trouble Code: P1235



Fuel Pump Control Circuit Malfunction

Possible Causes:



Fuel pump relay control circuit is open
 
Fuel pump relay control circuit is shorted to ground
 
Fuel pump relay power circuit is open
 
PCM has failed
 

Trouble Code: P1237



Fuel Pump Control Circuit Range/Performance

Possible Causes:



Fuel pump relay control circuit is shorted to system power (B+)
 
Fuel pump relay power circuit is open
 
PCM has failed
 

Trouble Code: P1244



Generator / Regulator System

Possible Causes:



GLI circuit is open or shorted to ground
 
GLI circuit is shorted to system power (B+)
 
Generator or voltage regulator is damaged or has failed
 
PCM has failed
 

Trouble Code: P1245



Generator / Regulator System

Possible Causes:



GLI circuit is open or shorted to ground
 
GLI circuit is shorted to system power (B+)
 
Generator or voltage regulator is damaged or has failed
 
PCM has failed
 

Trouble Code: P1246



Fuel Pump Control Circuit Range/Performance

Possible Causes:



GLI circuit is open or shorted to ground
 
GLI circuit is shorted to system power (B+)
 
Generator or voltage regulator is damaged or has failed
 
PCM has failed
 

Trouble Code: P1260



Anti-Theft System Signal Detected, Engine Disabled

Possible Causes:



Previous theft condition has occurred
 
Anti-Theft System is damaged or has failed
 

Trouble Code: P1270



Engine RPM or Vehicle Speed Limit Reached

Possible Causes:



Excessive wheel slippage (due to water, ice, mud or snow)
 
Engine over-revved with the gear selector in Neutral position
 
Vehicle was driven at a very high rate of speed
 

Trouble Code: P1285



Cylinder Head Temperature Sensor - Engine Overheated

Possible Causes:



Engine coolant level is low, or wrong coolant mixture
 
Engine overheat condition exists
 
CHT sensor is out-of-calibration or damaged
 
PCM has failed
 

Trouble Code: P1288



Cylinder Head Temperature Sensor Circuit Malfunction (Self-Test)

Possible Causes:



Engine not warm enough to begin the KOER Self-Test
 
CHT sensor is out-of-calibration or damaged
 
PCM has failed
 

Trouble Code: P1289



Cylinder Head Temperature Sensor Overheat Condition

Possible Causes:



Serious engine overheat condition exists
 
CHT sensor is out-of-calibration or damaged
 
PCM has failed
 

Trouble Code: P1290



Cylinder Head Temperature Sensor Low Input

Possible Causes:



CHT sensor signal circuit is shorted to ground
 
CHT sensor is damaged or has failed
 
PCM has failed
 

Trouble Code: P1299



Cylinder Head Temperature Sensor High Input

Possible Causes:



CHT sensor signal circuit is open
 
CHT sensor signal circuit is shorted to VRED
 
CHT sensor ground circuit is open
 
CHT sensor is damaged or has failed
 
PCM has failed
 

Trouble Code: P1309



Misfire Detection Monitor

Possible Causes:



CMP sensor is not properly synchronized in the engine
 
CMP sensor is damaged or has failed
 
PCM has failed
 

Trouble Code: P1336



Camshaft Position (SGC) Sensor Circuit Malfunction

Possible Causes:



CMP sensor signal circuit is open or shorted to ground
 
CMP sensor signal circuit is shorted to VREF or system power
 
CMP sensor power circuit open between sensor and main relay
 
CMP sensor is damaged or has failed
 
PCM has failed
 

 
label.common.footer.alt.autozoneLogo