REMOVAL & INSTALLATION
See Figure 1
- Raise and support the front end on jackstands.
- Remove the wheel.
- Remove the drum attaching screws and insert them in the threaded holes in the drum. Turn the screws inward, evenly, to force the rum off the hub.
- Thoroughly inspect the drum. Discard a cracked drum. If the drum is suspected of being out of round, or shows signs of wear or has a ridged or rough surface, have it turned on a lathe at a machine shop. The maximum oversize is stamped into the drum.
- Installation is the reverse of removal. Make sure that the holes are aligned for the attaching screws. Tighten the screws evenly to install the drum.