Mazda Trucks 1987-1993 Repair Guide

Outside Mirrors

Print

REMOVAL & INSTALLATION



Pickup and MPV

See Figures 1, 2, 3 and 4



Click image to see an enlarged view

Fig. Fig. 1: Using a small prying tool, pry off the interior sideview mirror trim panel ...



Click image to see an enlarged view

Fig. Fig. 2: ... then pull away the trim panel from the door



Click image to see an enlarged view

Fig. Fig. 3: Remove the 3 sideview mirror mounting screws using a phillips head screwdriver ...



Click image to see an enlarged view

Fig. Fig. 4: ... then pull the sideview mirror away and disengage the power mirror wiring connector

The mirrors can be removed from the door without disassembling the door liner or other components except on Navajo models. The mirrors may be manual, manual remote, or electric remote. If the mirror glass is broken, replacements may be available through your dealer or a glass shop. If the housing is cracked or damaged, the entire mirror must be replaced. To remove the mirror:

  1. If the mirror is manual remote, check to see if the adjusting handle is retained by a hidden screw, usually under the endcap on the lever. Or if it is retained by a threaded trim nut. If so, remove the screw, nut or other remote assembly retainer.
  2.  
  3. Remove the plastic delta cover from the door window corner where the mirror is mounted. It can be removed with a blunt plastic or wooden tool. Don't use a screwdriver, the plastic will be marred.
  4.  
  5. Depending on the model and style mirror, there may be concealed plugs or other minor parts under the delta cover. If electrical connectors are present, disconnect them.
  6.  
  7. Installation is the reverse of removal.
  8.  

Navajo

  1. The door panel must first be removed to gain access to the mounting nuts. Disconnect the harness connector if equipped with power mirrors.
  2.  
  3. Remove the mounting screws or nuts and lift off the mirror. Remove and discard the gasket.
  4.  
  5. When installing, make sure the gasket is properly positioned before tightening the screws.
  6.  

 
label.common.footer.alt.autozoneLogo