Mazda Trucks 1987-1993 Repair Guide

Seats

Print

REMOVAL & INSTALLATION



Pickups

See Figure 1

  1. Remove the seat anchor bolts.
  2.  
  3. Lift out the seat.
  4.  
  5. Installation is the reverse of removal.
  6.  



Click image to see an enlarged view

Fig. Fig. 1: Pickup seat removal/installation

MPV
DRIVER'S SEAT

See Figure 2

  1. Remove the fuel filler lid opener.
  2.  
  3. Remove the parking brake lever.
  4.  
  5. Remove the seat bracket covers.
  6.  
  7. Remove the seat leg covers.
  8.  
  9. Remove the seat bracket-to-floor bolts and lift out the seat.
  10.  
  11. Installation is the reverse of removal. Torque the bracket-to-floor bolts to 38 ft. lbs. (52 Nm).
  12.  



Click image to see an enlarged view

Fig. Fig. 2: MPV front seat components

FRONT RIGHT SEAT

See Figure 2

  1. Remove the jack cover.
  2.  
  3. Remove the jack and jack handle.
  4.  
  5. Remove the seat bracket covers.
  6.  
  7. Remove the seat leg covers.
  8.  
  9. Remove the seat bracket-to-floor bolts and lift out the seat.
  10.  
  11. Installation is the reverse of removal. Torque the bracket-to-floor bolts to 38 ft. lbs. (52 Nm).
  12.  

NO.1 REAR SEAT

See Figure 3

The seat is removed by simply unlatching the release levers on the seat legs.



Click image to see an enlarged view

Fig. Fig. 3: Rear no. 1 seat components

NO.2 REAR SEAT

See Figure 4

  1. Remove the seat bracket cover.
  2.  
  3. Remove the folding link bolts.
  4.  
  5. Remove the rear hinge bolts.
  6.  
  7. Remove the front hinge bolts.
  8.  
  9. Lift out the seat.
  10.  
  11. Installation is the reverse of removal. Torque all bolts to 22 ft. lbs. (30 Nm).
  12.  



Click image to see an enlarged view

Fig. Fig. 4: Rear seat no. 2 and seat mount removal/installation

Navajo

See Figure 5

  1. Remove the 4 seat track-to-floorpan screws (2 each side) and lift the seat and track assembly from the vehicle.
  2.  
  3. To remove the seat tracks from the seat cushion, position the seat upside down on a clean bench.
  4.  
  5. Disconnect the latch tie rod assembly and assist spring from the tracks.
  6.  
  7. Remove 4 track-to-seat cushion screws (2 each side) from the track assemblies. Remove the tracks from seat cushion.
  8.  



Click image to see an enlarged view

Fig. Fig. 5: Navajo manual front seat removal/installation

To install:
  1. Position the tracks to the seat cushion. Install the 4 track-to-seat cushion screws (2 each side) and tighten.
  2.  
  3. Connect the latch tie rod assembly and assist spring to the tracks.
  4.  
  5. Position the seat and track assembly in the vehicle.
  6.  
  7. Install 4 track-to-floorpan screws and tighten to specification.
  8.  

 
label.common.footer.alt.autozoneLogo