The coolant temperature sender is located in the following positions:
2.2L engine-left side rear of the engine, below the cylinder head2.6L engine-top front of the engine.3.0L engine (MPV)-top front of the engine, on the right-hand side of the intake manifold4.0L engine-top left front of the engine, on the intake manifold
- Remove the coolant temperature sender from the engine block.
- Attach an ohmmeter to the sender unit as follows:
- With the leads still attached, place the sender unit in a pot of cold water so that neither of the leads is immersed in the water. The portion of the sender unit which normally makes contact with the engine coolant should be submerged.
- Measure and note the resistance.
- Slowly heat the pot up (on the stove) to 190-210 degrees F (88-99 degrees C) and observe the resistance of the sender unit. The resistance should evenly and steadily decrease as the water temperature increases. The resistance should not jump drastically or decrease erratically.
- If the sender unit did not function as described, replace the sender unit with a new one.
REMOVAL & INSTALLATION
See Figure 1
Ensure that the engine is cold prior to opening the cooling system or removing the sender from the engine. The cooling system on a hot engine is under high pressures, and released hot coolant or steam can cause severe burns.
- Disconnect the negative battery cable.
- Remove the radiator cap to relieve any system pressure.
- Disconnect the wiring at the sender.
- Remove the coolant temperature sender from the engine.
- Coat the threads on the sender with Teflon® tape or electrically conductive sealer, then install the sender. Tighten the sender to 107-143 inch lbs. (12-16 Nm) on Navajo/B Series Pick-up, and 57-82 inch lbs. (6-9 Nm) on MPV.
- Attach the wiring to the sender and connect the negative battery cable.
- If necessary, add antifreeze to replace any lost coolant, then install the radiator cap.