Mazda Trucks 1994-1998 Repair Guide

Back-up Light Switch

Print

REMOVAL & INSTALLATION



See Figure 1



Click image to see an enlarged view

Fig. Fig. 1: Location of the back-up lamp switch

  1. Disconnect the negative battery cable.
  2.  
  3. Raise and support the vehicle safely.
  4.  
  5. Place the transmission in any position other than N .
  6.  
  7. Clean the area around the switch, then remove the switch.
  8.  

To install:
  1. Install the switch and tighten 8-12 ft. lbs. (11- 16Nm).
  2.  
  3. Reconnect the harness connector to the switch.
  4.  
  5. Lower the vehicle.
  6.  
  7. Reconnect the negative battery cable.
  8.  

 
label.common.footer.alt.autozoneLogo