Mazda Trucks 1994-1998 Repair Guide

RABS Electronic Control Module

Print

REMOVAL & INSTALLATION



B Series Pick-up
  1. Remove any instrument panel covers to gain access to the module.
  2.  
  3. Disconnect the wiring harness to the module.
  4.  
  5. Remove the retaining screws and remove the module.
  6.  

To install:
  1. Place the module in position against the under dash crossmember. Install and tighten the retaining bolts.
  2.  
  3. Connect the wiring harness to the module.
  4.  
  5. Install any instrument panels which were removed.
  6.  
  7. Check the system for proper operation.
  8.  

MPV

See Figure 1



Click image to see an enlarged view

Fig. Fig. 1: Location of the electronic control module

  1. Disconnect the negative battery cable.
  2.  
  3. Remove the left rear interior trim panel.
  4.  
  5. Disengage the wiring harness connector from the electronic control module.
  6.  
  7. Remove the mounting fasteners.
  8.  
  9. Remove the RABS electronic control unit from the vehicle.
  10.  
  11. Installation is the reverse of the removal procedure.
  12.  
  13. Check the system for proper operation.
  14.  

 
label.common.footer.alt.autozoneLogo