REMOVAL & INSTALLATION
See Figures 1 through 7
Fig. Fig. 1: Cross-sectional view of a nozzle holder/injector assembly
Fig. Fig. 2: Sectional view of an installed nozzle holder/injector assembly
Fig. Fig. 3: To remove a fuel injector, first disconnect the negative battery cable
Fig. Fig. 4: Use a flare nut wrench to loosen and disconnect the fuel line from the injector ...
Fig. Fig. 5: ... then disconnect the overflow tubes from the injector
Fig. Fig. 6: Use a ratchet and socket to loosen the fuel injector ...
Fig. Fig. 7: 1. Fuel injector... then remove the injector from the cylinder head
Disconnect the negtive battery cable.
Unbolt the fuel lines, then disconnect the overflow tubes.
Remove the injectors from the cylinder head.
If equipped with heat shields (washers), they must be replaced with new ones when reinstalling the fuel injector.
Installation is the reverse of removal.
Bleed the system by opening the bleed screw and operating the hand pump to evacuate any air.