Metro, Prizm 2000-2002

Ignition Lock Cylinder

Print

Removal & Installation



  1. Disconnect the negative battery cable.
  2.  
  3. Disable the Supplemental Inflatable Restraint (SIR) system, as outlined in the Chassis Electrical Section.
  4.  
  5. Remove the 3 screws and the steering column lower trim cover (6).
  6.  
  7. Remove the 1 screw and the steering column upper trim cover (7).
  8.  
  9. Insert the ignition key into the ignition lock cylinder (8).
  10.  
  11. Turn the key to the ACC position.
  12.  
  13. Use a screwdriver to push in the stop pin on the underside of the lock cylinder case (7).
  14.  
  15. Remove the ignition lock cylinder (8) from the ignition lock cylinder case (7).

    Click image to see an enlarged view

    Fig. Ignition switch and lock cylinder locations-Prizm

  16.  

To install:

  1. Insert the ignition key into the ignition lock cylinder (8). Ensure that the key is in the ACC position.
  2.  
  3. Insert the ignition lock cylinder (8) into the ignition lock cylinder case (7) until the stop pin engages.
  4.  
  5. Remove the key from the ignition lock cylinder.
  6.  
  7. Install the steering column upper trim cover (7). Secure with 1 screw.
  8.  
  9. Install the steering column lower trim cover (6). Secure with 3 screws.
  10.  
  11. Enable the SIR system, as outlined in the Chassis Electrical Section.
  12.  
  13. Connect the negative battery cable.
  14.  

 
label.common.footer.alt.autozoneLogo