Metro, Prizm 2000-2002

Turn Signal Switch

Print

Removal & Installation



Refer to Multi Function Switch procedure earlier in this section.

  1. Disconnect the negative battery cable.
  2.  
  3. Disable the Supplemental Inflatable Restraint (SIR) system, as outlined in the Chassis Electrical Section.
  4.  
  5. Remove the lower trim cover screws and the 2 lower trim cover screws that are located beneath the steering wheel.
  6.  
  7. The steering column lower trim cover.
  8.  
  9. Remove the steering column upper trim cover screw and upper trim cover from the steering column.
  10.  
  11. Inspect the base for damage. If damage to the base is observed, replace the turn signal, headlamp and windshield washer switch as an assembly.
  12.  
  13. Disconnect the turn signal/headlamp switch electrical connector.
  14.  
  15. Remove the 2 screws and the turn signal/headlamp switch.

    Click image to see an enlarged view

    Fig. Steering wheel and turn signal/headlamp and wiper/washer switch components-Prizm

  16.  

To install:

  1. Install the turn signal/headlamp switch to the steering column. Secure the switch with the 2 screws.
  2.  
  3. Connect the turn signal/headlamp switch electrical connector.
  4.  
  5. Install the steering column upper trim cover to the vehicle. Secure the trim cover with the screw.
  6.  
  7. Install the steering column lower trim cover to the vehicle. Secure the trim cover with the 3 screws.
  8.  
  9. Enable the SIR system, as outlined in the Chassis Electrical Section.
  10.  
  11. Connect the negative battery cable.
  12.  

 
label.common.footer.alt.autozoneLogo