Mitsubishi Endeavor 2004-06

Removal & Installation

Print

  1. Disconnect the negative battery cable.
  2.  
  3. Drain the engine coolant to a level below the sensor.
  4.  
  5. Unplug the sensor connector, then remove the sensor.
  6.  

To install:

  1. Installation is the reverse of the removal procedure.
  2.  
  3. Fill the engine with the proper type and amount of engine coolant. Check for leaks.
  4.  
  5. Connect the negative battery cable. On 2005-2006 vehicles, turn the ignition ON and then OFF , and keep it off for at least ten seconds.
  6.  

  1. Disconnect the negative battery cable.
  2.  
  3. Drain the engine coolant to a level below the intake manifold.
  4.  
  5. Unplug the sensor wiring harness.
  6.  
  7. Unplug the ECT sensor electrical connector
  8.  
  9. Unthread and remove the sensor from the engine. Use a deep socket and an extension to reach the ECT sensor, remove the ECT sensor from the thermostat housing
  10.  

To install:

  1. Coat the threads of the sensor with a suitable sealant and thread into the housing.
  2.  
  3. Tighten the sensor to 22 ft. lbs. (30 Nm).
  4.  
  5. Refill the cooling system to the proper level.
  6.  
  7. Attach the electrical connector to the sensor securely.
  8.  
  9. Connect the negative battery cable.
  10.  

 
label.common.footer.alt.autozoneLogo