Mitsubishi Endeavor 2004-06

Brake Pads

Print

Removal & Installation



Front & Rear
  1. Before servicing the vehicle, refer to the Precautions section.
  2.  
  3. Remove12
  4.  
  5. Raise and safely support the vehicle.
  6.  
  7. Remove or disconnect the following:

    Wheel and tire assembly
     
    Lower caliper guide pin bolt
     
    Caliper from the caliper support
     
    Disc brake pads, shims, and the clips from the caliper support
     

  8.  


    Click image to see an enlarged view

    Fig. Exploded view of the front brake pads and component tightening specifications



    Click image to see an enlarged view

    Fig. Exploded view of the rear brake pads and component tightening specifications


To install:

  1. Clean the exposed portion of the caliper piston, then press the piston back into the caliper bore using the old inner brake pad and a C-clamp.
  2.  
  3. Install or connect the following:

    Disc brake pads, shims, and the clips. Make sure the shims and clips are properly positioned.
     
    Caliper over the rotor so the caliper engages the adapter correctly
     
    Mounting pin(s)
     
    Wheel and tire assembly and lower the vehicle
     

  4.  
  5. Apply the brake pedal several times until a firm pedal is obtained. Check the fluid level in the master cylinder and add fluid, as necessary.
  6.  

 
label.common.footer.alt.autozoneLogo