Removal & Installation
- Before servicing the vehicle, refer to the Precautions Section.
- Drain the engine coolant.
Remove or disconnect the following:
Negative battery cable
Install the crankshaft pulley. Using Pulley Holder MB991800 and the 2 Crankshaft Pulley Holder Pin tools MD991802, or equivalent to hold the crankshaft pulley, and a socket torque wrench, torque the crankshaft pulley bolt to 136 ft. lbs. (185 Nm).
- Connect the negative battery cable. On 2005-2006 vehicles, turn the ignition ON and then OFF , and keep it off for at least ten seconds.
- Refill the cooling system.