Mitsubishi Endeavor 2004-06

Front Crankshaft Seal

Print

Removal & Installation



  1. Before servicing the vehicle, refer to the Precautions section.
  2.  
  3. Drain the crankcase.
  4.  
  5. Drain and recycle the engine coolant.
  6.  
  7. Remove or disconnect the following:

    Negative battery cable
     

  8.  


CAUTION
Wait at least 90 seconds after the negative battery cable is disconnected to prevent possible deployment of the air bag.



Timing belt
 
Crankshaft Position (CKP) sensor
 
Crankshaft sprocket
 
Crankshaft sensing blade
 
Crankshaft spacer and key
 
Front oil seal
 



Click image to see an enlarged view

Fig. Exploded view of the crankshaft front oil seal-3.8L engine

To install:



Front oil seal. Apply oil to the seal, and install using Crankshaft Front Oil Seal Installer tool no. MD998717.
 
Crankshaft key and spacer.
 
Crankshaft sensing blade
 
CKP sensor
 


NOTE
To be sure the crankshaft pulley bolt does not loosen, make sure the clean the mating areas of the crankshaft, spacer, sensing blade and sprocket.



Crankshaft sprocket
 
Timing belt
 

  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Drain the engine oil. Drain the engine coolant.
  4.  
  5. Remove or disconnect the following:
    CAUTION
    Wait at least 90 seconds after the negative battery cable is disconnected to prevent possible deployment of the air bag.



    Negative battery cable
     



    Timing belt
     
    Crankshaft Position (CKP) sensor
     
    Crankshaft sprocket
     
    Crankshaft sensing blade
     
    Crankshaft spacer and key
     
    Front oil seal

    Click image to see an enlarged view

    Fig. Front oil seal and related components

     

  6.  

To install:



Front oil seal. Apply oil to the seal, and install using Crankshaft Front Oil Seal Installer tool no. MD998717.
 
Crankshaft key and spacer.
 
Crankshaft sensing blade
 
CKP sensor
 


NOTE
To be sure the crankshaft pulley bolt does not loosen, make sure the clean the mating areas of the crankshaft, spacer, sensing blade and sprocket.



Crankshaft sprocket
 
Timing belt
 

  1. Connect the negative battery cable. On 2005-2006 vehicles, turn the ignition ON and then OFF , and keep it off for at least ten seconds.
  2.  

 
label.common.footer.alt.autozoneLogo