Mitsubishi Endeavor 2004-06

Fuel Injector Rail (Fuel Supply Manifold)

Print

Removal & Installation



  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Properly relieve the fuel system pressure. Disconnect the negative battery cable.
  4.  
  5. Remove or disconnect the following:

    Air cleaner assembly, ducts and air intake hose
     
    Intake manifold plenum
     
    Ignition coil connectors and coils
     
    Injector connectors
     
    High pressure fuel hose and O-ring
     
    Blow-by hose connection
     
    Fuel rail, injector and damper assembly, as necessary. Only earlier production vehicles will have a fuel damper.
     
    Insulators from the fuel rail

    Click image to see an enlarged view

    Fig. Fuel rail and related components

     

  6.  

To install:

  1. Install or connect the following:

    Fuel rail and insulators. Torque the bolts to 102 inch lbs. (12 Nm).
     
    Injector connectors
     
    Blow-by hose connection
     
    High pressure fuel hose and O-ring. Torque the bolts to 44 inch lbs. (5.0 Nm).
     
    Ignition coils and connectors
     
    Intake manifold plenum
     
    Air cleaner assembly, ducts and air intake hose
     

  2.  
  3. Connect the negative battery cable. On 2005-2006 vehicles, turn the ignition ON and then OFF , and keep it off for at least ten seconds.
  4.  

 
label.common.footer.alt.autozoneLogo