Mitsubishi Endeavor 2004-06

Differential Carrier

Print

Removal & Installation



  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Drain the differential gear oil. Raise and support the vehicle safely.
  4.  
  5. Remove or disconnect the following:
    NOTE
    Matchmark the installed relation of the propeller shaft to the differential carrier before removal.



    Center exhaust pipe
     
    Rear driveshaft
     
    Stabilizer bar bushing
     



    Propeller shaft from the differential carrier. Suspend the propeller shaft from the body to avoid damaging or bending the shaft.
     
    Differential mount bracket
     
    Hose and nipple
     
    Retainers and differential carrier. Discard the washers.

    Click image to see an enlarged view

    Fig. Rear differential carrier and related components

     

  6.  

To install:

  1. Install or connect the following:

    Differential carrier. Tighten the retainers, with new washers, to the specifications shown in the illustration.
     
    Nipple and hose
     
    Differential mount bracket. Tighten the retainers, with new washers, to the specifications shown in the illustration.
     
    Propeller shaft, aligning the matchmarks made during removal.
     

  2.  
  3. Fill the differential with the proper grade and type gear oil.
  4.  
  5. Check and adjust the rear wheel alignment, as necessary.
  6.  

 
label.common.footer.alt.autozoneLogo