Mitsubishi Endeavor 2004-06

Windshield Wiper System

Print

Wiper Motor



Removal & Installation
  1. Disconnect the negative battery cable.
  2.  
  3. Remove the nut cap and nut, then remove the left side wiper arm and blade assembly.
  4.  
  5. Remove the wiper arm cover.
  6.  
  7. Remove the nut caps and nuts, then remove the right side wiper arm and blade assembly.
  8.  
  9. Remove the fender cover.
  10.  
  11. Remove the left and right front deck garnish.
  12.  
  13. Remove the 5 retaining bolts, then remove the windshield wiper motor and link assembly.
  14.  

To install:

  1. Install the windshield wiper motor and link assembly and secure with the 5 retaining bolts. Tighten the bolts to 39-47 inch lbs. (4.4-5.4 Nm).
  2.  
  3. Install the left and right front deck garnish.
  4.  
  5. Install the fender cover.
  6.  
  7. Install the right side wiper arm and blade assembly, as follows:
    1. Install the wiper blade at the position shown in the accompanying illustration. Standard value (B): 2.50-2.90 in. (64-74mm).
    2.  
    3. Install the nuts and tighten to 25-29 ft. lbs. (34-40 Nm), then install the nut caps.

      Click image to see an enlarged view

      Fig. Proper installed position of the right side wiper blade

    4.  

  8.  
  9. Install the wiper arm cover.
  10.  
  11. Install the left side wiper arm and blade assembly, as follows:
    1. Install the wiper blade at the position shown in the accompanying illustration. Standard value (D): 2.37-2.67 in. (58-68mm).
    2.  
    3. Install the nut and tighten to 25-29 ft. lbs. (34-40 Nm), then install the nut caps.

      Click image to see an enlarged view

      Fig. Proper installed position of the left side wiper blade

    4.  

  12.  
  13. Connect the negative battery cable. On 2005-2006 vehicles, turn the ignition ON and then OFF , and keep it off for at least ten seconds.
  14.  

 
label.common.footer.alt.autozoneLogo