Mitsubishi Outlander 2003-06

Removal & Installation

Print

  1. Position the front wheels in the straight-ahead position and place the key in the LOCK position. Remove the key from the ignition lock cylinder.
  2.  
  3. Disconnect the negative battery cable and insulate the cable end with high-quality electrical tape or similar non-conductive wrapping.
    CAUTION
    Wait at least 1 minute before working on the vehicle. The air bag system is designed to retain enough voltage to deploy the air bag for a short period of time after the battery has been disconnected.



    Click image to see an enlarged view

    Fig. Insulate the negative battery cable to prevent accidental deployment of the air bag

  4.  
  5. Insert Special Tool MB990784, or equivalent trim removal tool, at the indicated position to remove the cover.
    NOTE
    The special tool can be inserted through the notch behind the area shown.



    Click image to see an enlarged view

    Fig. Insert Special Tool MB990784, or equivalent, at the indicated position to remove the cover

  6.  
  7. Remove the air bag module assembly, as follows:
    1. Slide section A of the clock spring connector shown in the illustration in the arrow direction, then detach the connector.

      Click image to see an enlarged view

      Fig. Slide section A of the clock spring connector shown in the illustration in the arrow direction, then detach the connector

    2.  
    3. Remove the Torx® screws, then carefully remove the air bag module from the steering wheel. Lay the module, face up, on a workbench out of the way.
    4.  

  8.  
  9. Use special tool MB990803 or equivalent steering wheel puller to remove the steering wheel from the shaft.

    Click image to see an enlarged view

    Fig. Remove the steering wheel using a suitable puller

  10.  
  11. Disconnect the sub-harness.

    Click image to see an enlarged view

    Fig. Exploded view of the steering wheel mounting and tightening specifications

  12.  

To install:

  1. Installation is the reverse of the removal procedure, noting the following:
    1. When installing the steering wheel, and air bag module ensure that the harness of the clock spring does not become caught or tangled.
    2.  
    3. Before installing the steering wheel, and air bag module turn the vehicle-s front wheels to the straight-ahead position and align the mating marks of the clock spring.
    4.  
    5. After securing the steering wheel, turn the steering wheel all the way in both directions to confirm that the steering wheel rotation is normal.
    6.  
    7. Refer to the accompanying illustration for tightening specifications.
    8.  
    9. Remove the tape or insulation from the negative battery cable, then connect the cable.
    10.  
    11. Turn the ignition switch ON and make sure the SRS lamp lights for about 7 seconds. If so, the SRS system is operating properly.
    12.  

  2.  

 
label.common.footer.alt.autozoneLogo