Mitsubishi Outlander 2003-06

Rear Window Wiper/Washer System

Print

Wiper Motor



  1. Disconnect the negative battery cable.
  2.  
  3. Remove the nut cap, nut and the rear wiper arm and blade assembly.
  4.  
  5. Remove the liftgate lower trim.
  6.  
  7. Remove the liftgate waterproof film.

    Click image to see an enlarged view

    Fig. Exploded view of the rear liftgate trim



    Click image to see an enlarged view

    Fig. Rear liftgate trim clip and claw locations

  8.  
  9. Remove the rear wiper motor assembly.

    Click image to see an enlarged view

    Fig. Exploded view of the rear wiper motor and related components

  10.  

To install:

  1. Install the rear wiper motor assembly. Tighten the retainers to 52-78 inch lbs. (6.0-8.8 Nm).
  2.  
  3. Install the liftgate waterproof film.
  4.  
  5. Install the liftgate lower trim.
  6.  
  7. Connect the negative battery cable.
    NOTE
    Before installing the rear wiper arm and blade, operate the rear wiper motor so the motor stops at the predetermined park position.

  8.  
  9. Install the rear wiper arm and blade assembly, as follows:
    1. Install the wiper blade assembly, and adjust so the blade end stops in the position shown in the accompanying illustration.

      Click image to see an enlarged view

      Fig. Proper wiper blade installation-Value A = 0.88-1.38 in. (25-35mm)

    2.  
    3. Tighten the retaining nut to 36-60 inch lbs. (4.0-6.8 Nm).
    4.  

  10.  

 
label.common.footer.alt.autozoneLogo