Mitsubishi Raider 2006

Crankshaft Damper (Balancer)

Print

Removal & Installation



  1. Disconnect negative cable from battery.
  2.  
  3. Remove radiator fan.
  4.  
  5. Remove accessory drive belt,
  6.  
  7. Remove crankshaft damper bolt.
  8.  
  9. Remove damper using Mitsubishi special tools 8513 insert and 1026 three jaw puller.
  10.  

To install:

  1. Clean timing chain cover and block surface using rubbing alcohol.
  2.  
  3. Inspect the water passage O-rings for any damage, and replace as necessary.
  4.  
  5. Apply RTV sealer to front cover using a 3 to 4mm thick bead.
  6.  
  7. Install cover. Tighten fasteners in sequence to 43 ft. lbs. (58 Nm).
  8.  
  9. Install crankshaft damper.
  10.  
  11. Install the A/C compressor.
  12.  
  13. Install the generator.
  14.  
  15. Install accessory drive belt tensioner.
  16.  
  17. Install radiator upper and lower hoses.
  18.  
  19. Install both heater hoses.
  20.  
  21. Install radiator fan.
  22.  
  23. Fill cooling system.
  24.  
  25. Connect the battery negative cable.
  26.  

 
label.common.footer.alt.autozoneLogo