Mitsubishi Raider 2006

Rear Main Seal

Print

Removal & Installation



  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Remove or disconnect the following:

    Transmission
     
    Flexplate
     

  4.  
  5. Thread Oil Seal Remover 8506 into the rear main seal as far as possible and remove the rear main seal.

    Click image to see an enlarged view

    Fig. Removing the rear main seal (1) with special tool 8506 (2)

  6.  

To install:

  1. Install or connect the following:

    Seal Guide 8349-2 onto the crankshaft
     
    Rear main seal on the seal guide
     
    Rear main seal, using the Crankshaft Rear Oil Seal Installer 8349 and Driver Handle C-4171; tap it into place until the installer is flush with the cylinder block
     
    Flexplate. Tighten the bolts to 45 ft. lbs. (60 Nm).
     
    Transmission
     

  2.  
  3. Start the engine and check for leaks.

    Click image to see an enlarged view

    Fig. Installing rear main seal using Special Tool 8349 (2) and C-4171 (3)

  4.  

 
label.common.footer.alt.autozoneLogo