Montana SV6 (2006), Relay, Terraza, Uplander (2005-2007)

Removal & Installation

Print

  1. Disable the air bag system for zone 3.
  2.  
  3. On the back side of the steering wheel are 4 openings; place the wheel so that 2 openings are on top.
  4.  
  5. Install the J-44298 Driver Air Bag Removal Tool, and pull the handle back toward the steering wheel, away from the steering column, releasing the spring loaded fasteners at the same time. Repeat the steps for the other 2 openings.
  6.  
  7. Tilt the steering wheel module toward the rear of the vehicle to access the horn ground lead and connectors.
  8.  
  9. Disconnect the module electrical connector.
  10.  
  11. Disconnect the steering wheel control electrical connector.
  12.  
  13. Remove the steering wheel nut.
  14.  
  15. Install a steering wheel puller to remove the steering wheel.
  16.  
  17. Remove the tool from the steering wheel.
  18.  
  19. If equipped, remove the controls and the control harness from the steering wheel.
  20.  

To install:

  1. If equipped, install the controls and the control harness to the steering wheel.
  2.  
  3. Install the wiring through the steering wheel.
  4.  
  5. Install the steering wheel.
  6.  
  7. Connect the steering wheel control electrical connector.
  8.  
  9. Install the steering wheel nut and tighten to 30 ft. lbs. ( 40 Nm).
  10.  
  11. Install the inflator module.
  12.  
  13. Enable the air bag system.
  14.  

 
label.common.footer.alt.autozoneLogo