Montana SV6 (2006), Relay, Terraza, Uplander (2005-2007)

Removal & Installation

Print

  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Disconnect the negative battery cable.
  4.  
  5. Drain the engine cooling system.
  6.  
  7. Relieve the belt tension and remove the accessory drive belt.
  8.  
  9. Remove or disconnect the following:

    Water pump pulley
     
    Water pump bolts
     
    Water pump and gasket
     

  10.  

To install:

  1. Clean the gasket mating surfaces.
  2.  
  3. Install or connect the following:

    Water pump using a new gasket. Tighten the water pump bolts to 89 inch lbs. (10 Nm)
     
    Water pump pulley and tighten the bolts to 18 ft. lbs. (25 Nm).
     
    Drive belt
     
    Negative battery cable
     

  4.  
  5. Refill the engine cooling system.
  6.  
  7. Run the engine and check for leaks.

    Click image to see an enlarged view

    Fig. Showing the water pump and gasket on the 3.5L engine



    Click image to see an enlarged view

    Fig. Remove the water pump pulley bolts and pulley-3.9L engine shown



    Click image to see an enlarged view

    Fig. Water pump and gasket mounting on the 3.9L engine

  8.  

 
label.common.footer.alt.autozoneLogo