Montana, Silhouette, Venture 2000-2005

Multi-Function (Combination) Switch

Print

Removal & Installataion



  1. Disable the air bag system for zone 3.
  2.  
  3. Remove the steering column trim covers.
  4.  
  5. Disconnect the electrical connectors from the multifunction switch.
  6.  
  7. Remove the wiring harness from the steering column harness strap.
  8.  
  9. Disconnect the multifunction switch electrical connectors from the steering column wiring harness.
  10.  
  11. Remove the multifunction switch retaining screws.
  12.  
  13. Remove the multifunction switch from the steering column.
  14.  
  15. Remove the SIR coil from the steering column shaft.
  16.  

To install:

  1. Install the multifunction switch to the steering column tilt head. Verify that the electrical contact of the turn signal switch rests on the horn ring.
  2.  
  3. Install the multifunction switch screws and tighten to 26 inch lbs. (3 Nm).
  4.  
  5. Install 2 electrical connectors of the multifunction switch into the bulkhead connector.
  6.  
  7. Connect the multifunction switch connector to the SIR coil connector.
  8.  
  9. Attach the wire harness to the steering column with new wire harness straps.
  10.  
  11. Install the wire harness to the wire harness strap.
  12.  
  13. Install the SIR coil to the steering column shaft.
  14.  
  15. Install the upper and lower trim covers.
  16.  
  17. Enable the air bag system.
  18.  

 
label.common.footer.alt.autozoneLogo