Montana, Silhouette, Venture 2000-2005

Removal & Installation

Print

  1. Remove the HVAC control module.
  2.  
  3. Remove the defroster door.
  4.  
  5. Remove the air distribution case cover bolts/screws.
  6.  
  7. Remove the air distribution case cover.
  8.  
  9. Remove the mode actuator bolts/screws.
  10.  
  11. Remove the mode actuator.
  12.  
  13. Remove the mode actuator lever cover bolts/screws.
  14.  
  15. Remove the mode actuator lever cover.
  16.  
  17. Remove the mode actuator cam.
  18.  
  19. Remove the mode actuator levers.
  20.  
  21. Remove the mode door.
  22.  

To install:

  1. Install the mode door.
  2.  
  3. Install the mode actuator levers (3, 4, and 6). The pin on lever (4) should be seen through the opening in lever (6).
  4.  
  5. Install the mode actuator cam (1). The pin on lever (3) should be seen through this opening (2) in the cam. The pin on lever (6) should be seen through this opening (5) in the cam.

    Click image to see an enlarged view

    Fig. Installing the mode actuator levers

  6.  
  7. Install the mode actuator lever cover.
  8.  
  9. Install the mode actuator lever cover bolts/screws.
  10.  
  11. Install the mode actuator.
  12.  
  13. Install the mode actuator bolts/screws.
  14.  
  15. Install the air distribution case cover.
  16.  
  17. Install the air distribution case cover bolts/screws.
  18.  
  19. Install the defroster door.
  20.  
  21. Re-calibrate the actuators. For additional information, refer to the following section, -Actuator Calibration.-
  22.  

 
label.common.footer.alt.autozoneLogo