MonteCarlo 2000

Consoles

Print

Removal & Installation



Specific to:

Chevrolet Lumina 1997-2000

Chevrolet Monte Carlo 1997-2000

  1. Disconnect the negative battery cable after first disabling the Theftlock® feature of the radio, if equipped.
  2.  
  3. Remove the front floor console trim plate using the following procedure:
    1. Remove the cigarette lighter.
    2.  
    3. Remove the transaxle shift handle.
    4.  
    5. Remove the front floor console trim plate by unsnapping from the console.
    6.  
    7. Detach the automatic transaxle control indicator socket and bulb from the trim plate and detach the electrical connector from the trim plate.
    8.  

  4.  



Click image to see an enlarged view

Fig. Console mounting-Chevrolet models shown

  1. Remove the CD storage bin at the front of the console by unsnapping it.
  2.  
  3. Raise the console armrest and remove the compartment mat. Remove the screws from console.
  4.  
  5. Detach the electrical connectors and remove the front floor console from the vehicle.
  6.  
  7. Installation is the reverse of the removal process. Start with the front right console retaining screws and continue in a clockwise order. Tighten the screws to 106 inch lbs. (12 Nm).
  8.  
  9. Connect the negative battery cable.
  10.  

Specific to:

Buick Century 1997-2000

Buick Regal 1997-2000

Chevrolet Lumina 1997-2000

Chevrolet Monte Carlo 1997-2000

Oldsmobile Cutlass Supreme 1997

Oldsmobile Intrigue 1998-2000

Pontiac Grand Prix 1997-2000

  1. Disconnect the negative battery cable.
  2.  
  3. Apply the parking brake.
  4.  
  5. Reposition the transaxle shift lever to the LOW position.
  6.  
  7. Remove the console trim plate using the following procedure:
    1. Pull the trim plate upwards, starting at the front and working back to release the tabs at the retainers.
    2.  
    3. Detach the electrical connectors from the driver's seat heater switch, if equipped.
    4.  
    5. Remove the trim plate from the vehicle.
    6.  

  8.  
  9. Remove the rubber mat from the storage compartment in the console. Remove the screws from the storage compartment.
  10.  
  11. Remove the screws from the console mounting bracket at the rear of the transaxle shifter lever.
  12.  
  13. Remove the screws from the forward edge of the console.
  14.  
  15. Detach the electrical connectors and pull the console rearward to release the tabs from the retainers in the instrument panel. Remove the console from the vehicle.
  16.  
  17. Installation is the reverse of the removal process. Align the console over the transaxle shifter and position the console tabs to the retainers in the instrument panel. Press the console forward into the retainers until fully seated. Use care to align the console with the mounting brackets.
  18.  
  19. Once the console is installed, return the transaxle shift lever to PARK. Release the parking brake.
  20.  
  21. Connect the negative battery cable.
  22.  

 
label.common.footer.alt.autozoneLogo