MonteCarlo 2000

Brake Backing Plate

Print

Removal & Installation



  1. Raise and safely support the vehicle.
  2.  
  3. Mark the relationship of the wheel to the axle flange to help maintain wheel balance after assembly.
  4.  
  5. Remove the tire and wheel assembly.
  6.  
  7. Remove the brake drum, as outlined earlier in this section.
  8.  
  9. Remove the wheel cylinder, as outlined earlier in this section.
  10.  
  11. Disconnect the parking brake cable from the backing plate.
  12.  
  13. Remove the hub and bearing assembly, as outlined in Section 8 of this vehicle.
  14.  
  15. Remove the brake backing plate from the vehicle.
  16.  

To install:

  1. Install the brake backing plate.
  2.  
  3. Install the hub and bearing assembly, as outlined in Section 8 of this manual.
  4.  
  5. Connect the parking brake cable to the backing plate.
  6.  
  7. Install the wheel cylinder, as outlined earlier in this section.
  8.  
  9. Properly bleed the brake hydraulic system, as outlined later in this section.
  10.  

 
label.common.footer.alt.autozoneLogo