MonteCarlo 2000

Upper Control Arms

Print

Removal & Installation



  1. Remove the strut from the vehicle using the procedures found in this section.
  2.  
  3. Mount the strut in a strut compressor tool.
  4.  
  5. Use the strut compressor forcing screw to compress the spring just enough to release the tension from the strut mount.
  6.  
  7. Remove the strut shaft nut.
  8.  
  9. Relieve the spring tension and remove the spring from the strut.
  10.  



Click image to see an enlarged view

Fig. Exploded view of the rear strut and coil spring and the special strut compressor recommended for disassembly

To install:

  1. Inspect all components for wear or damage.
  2.  
  3. Install the rear spring lower insulator. Make sure the lower spring is visible between the step and the location mark on the insulator.
  4.  
  5. Install the rear suspension spring and the dust shield to the lower insulator. Install the jounce bumper and strut mount.
  6.  
  7. Use a strut compressor to compress the strut, working the strut shaft through the strut mount.
  8.  
  9. Compress the strut and spring assembly enough to install the strut shaft nut. Torque the nut to 55 ft. lbs. (75 Nm).
  10.  
  11. Install the strut into the vehicle using the procedures found in this section.
  12.  

 
label.common.footer.alt.autozoneLogo