Neon, 2000 - 2005

Removal & Installation (2 of 12)

Print

The crankshaft position sensor mounts to the engine block behind the generator, just above the oil filter.

  1. Disconnect electrical connector from crankshaft position sensor.
  2.  
  3. Remove sensor mounting screw. Remove sensor.
  4.  
  5. Disconnect the negative battery cable.
  6.  
  7. Raise vehicle and support.
  8.  
  9. Disconnect the electrical connector.
  10.  
  11. Remove bolt from Crankshaft sensor.
  12.  
  13. Remove sensor.

    Click image to see an enlarged view

    Fig.

  14.  

To install:

The crankshaft position sensor mounts to the engine block behind the generator, just above the oil filter

  1. Install sensor. Install sensor mounting screw and tighten.
  2.  
  3. Connect electrical connector to crankshaft position sensor.
  4.  
  5. Install bolt and tighten to 10 Nm (90 inch lbs.).
  6.  
  7. Connect the electrical connector.

    Click image to see an enlarged view

    Fig.

  8.  
  9. Lower vehicle. Connect the negative battery cable.
  10.  

 
label.common.footer.alt.autozoneLogo