Before servicing any vehicle, please be sure to read all of the following precautions, which deal with personal safety, prevention of component damage, and important points to take into consideration when servicing a motor vehicle:
Observe all applicable safety precautions when working around fuel. Whenever servicing the fuel system, always work in a well-ventilated area. Do NOT allow fuel spray or vapors to come in contact with a spark, open flame, or excessive heat (a hot drop light, for example). Keep a dry chemical fire extinguisher near the work area. Always keep fuel in a container specifically designed for fuel storage; also, always properly seal fuel containers to avoid the possibility of fire or explosion. Refer to the additional fuel system precautions later in this section.
Fuel injection systems often remain pressurized, even after the engine has been turned
. The fuel system pressure must be relieved before disconnecting any fuel lines. Failure to do so may result in fire and/or personal injury.
Brake fluid often contains Polyglycol Ethers and Polyglycols. Avoid contact with the eyes and wash your hands thoroughly after handling brake fluid. If you do get brake fluid in your eyes, flush your eyes with clean, running water for 15 minutes. If eye irritation persists, or if you have taken brake fluid internally, IMMEDIATELY seek medical assistance.
The EPA warns that prolonged contact with used engine oil may cause a number of skin disorders, including cancer. You should make every effort to minimize your exposure to used engine oil. Protective gloves should be worn when changing oil. Wash your hands and any other exposed skin areas as soon as possible after exposure to used engine oil. Soap and water, or waterless hand cleaner should be used.
The air bag system must be disabled (negative battery cable disconnected and/or air bag system main fuse removed) for at least 30 seconds before performing service on or around system components, steering column, instrument panel components, wiring and sensors. Failure to follow safety and disabling procedures could result in accidental air bag deployment, possible personal injury and unnecessary system repairs.
Always wear safety goggles when working with, or around, the air bag system. When carrying a non-deployed air bag, be sure the bag and trim cover are pointed away from your body. When placing a non-deployed air bag on a work surface, always face the bag and trim cover upward, away from the surface. This will reduce the motion of the module if it is accidentally deployed. Refer to the additional air bag system precautions later in this section.
Disconnecting the negative battery cable on some vehicles may interfere with the functions of the on-board computer system(s) and may require the computer to undergo a relearning process once the negative battery cable is reconnected.
It is critically important to observe all instructions regarding ground disconnects, ignition switch positions, etc., in each diagnostic routine provided. Ignoring these instructions can result in false readings, damage to electronic components or circuits, or personal injury.