Neon, 2000-2005

Charging the System

Print


WARNING
A small amount of refrigerant oil is removed from the A/C system each time the refrigerant system is recovered and evacuated. Before charging the A/C system, you MUST replenish any oil lost during the recovery process. Refer the equipment manufacturer instructions for more information.

  1. Evacuate the refrigerant system, refer to the EVACUATING THE SYSTEM procedure in this section.
  2.  
  3. A manifold gauge set and a R-134a refrigerant recovery/recycling/charging station that meets SAE Standard J2210 should still be connected to the refrigerant system.
  4.  
  5. Measure the proper amount of refrigerant and heat it to 52° C (125° F) with the charging station. See the operating instructions supplied by the equipment manufacturer for proper use of this equipment.
  6.  
  7. Open both the suction and discharge valves, then open the charge valve to allow the heated refrigerant to flow into the system.
  8.  
  9. When the transfer of refrigerant has stopped, close both the suction and discharge valves.
  10.  
  11. If all of the refrigerant charge did not transfer from the dispensing device, open all of the windows in the vehicle and set the heater-air conditioner controls so that the compressor is engaged and the blower motor is operating at its lowest speed setting. Run the engine at a steady high idle (about 1400 rpm). If the compressor will not engage, test the compressor clutch control circuit and repair as required.
  12.  
  13. Open the suction valve to allow the remaining refrigerant to transfer to the refrigerant system.
    CAUTION
    Take care not to open the discharge (high pressure) valve at this time. Failure to follow this warning can result in possible personal injury or death.

  14.  
  15. Close the suction valve and test the system performance.
  16.  
  17. Disconnect the charging station and manifold gauge set from the refrigerant system service ports.
  18.  
  19. Reinstall the caps onto the refrigerant system service ports.
  20.  


CAUTION
Refer to the applicable warnings and cautions at the beginning of this section before performing the following operation. Failure to follow the warnings and cautions could result in property damage, personal injury or death.


NOTE
Always refer to the A/C Under hood Specification Label for the refrigerant fill capacity of the vehicle being serviced.

After all refrigerant system leaks have been repaired and the refrigerant system has been evacuated, a refrigerant charge can be injected into the system. For the proper amount of the refrigerant charge, always refer to the A/C Under hood Specification Label located in the engine compartment. An R-134a refrigerant recovery/recycling/charging station that meets SAE Standard J2210 must be used to charge the refrigerant system with R-134a refrigerant. See the operating instructions supplied by the equipment manufacturer for proper care and use of this equipment.

 
label.common.footer.alt.autozoneLogo