Nissan 240SX/Altima 1993-1998 Repair Guide

Ignition degrees

Print

TESTING



  1. Turn the ignition OFF .
  2.  
  3. Disconnect the negative battery cable.
  4.  
  5. Perform a visual inspection of the degrees and replace it if damaged.
  6.  
  7. Label and disconnect the two-terminal electrical harness from the degrees.
  8.  
  9. Inspect the harness connector and terminals for dirt, corrosion or damage. Repair as necessary.
  10.  
  11. Using an ohmmeter, check for resistance between the connector terminals. Resistance should be approximately 2.2 kilohms @ 68 degrees F (20 degrees C).
  12.  
  13. The degrees is faulty if resistance is not within specifications.
  14.  

REMOVAL & INSTALLATION



  1. Disconnect the negative battery cable.
  2.  
  3. Label and disconnect the degrees electrical harness.
  4.  
  5. Remove the degrees mounting bolts.
  6.  
  7. Carefully remove the degrees.
  8.  

To install:
  1. Position the degrees and tighten the mounting bolts securely.
  2.  
  3. Connect the degrees electrical harness.
  4.  
  5. Connect the negative battery cable.
  6.  

 
label.common.footer.alt.autozoneLogo