Nissan 240SX/Altima 1993-1998 Repair Guide

Speakers

Print

REMOVAL & INSTALLATION



Front

See Figure 1



Click image to see an enlarged view

Fig. Fig. 1: The front speaker is retained in a plastic housing by four screws. Depress the clip (arrow) to disconnect the speaker electrical harness

  1. Disconnect the negative battery cable.
  2.  
  3. Remove the front door panel.
  4.  
  5. Remove the four speaker attaching screws.
  6.  

Take care not to damage the speaker cone.

  1. Pull the speaker from the plastic housing.
  2.  
  3. Depress the clip and disconnect the electrical harness.
  4.  

To install:
  1. Connect the speaker electrical harness.
  2.  
  3. Position the speaker in the plastic housing.
  4.  
  5. Install and tighten the four speaker attaching screws.
  6.  

Hand-tighten the screws only. Overtightening can damage the plastic housing.

  1. Install the front door panel.
  2.  
  3. Connect the negative battery cable.
  4.  

Rear

See Figures 2, 3, 4 and 5



Click image to see an enlarged view

Fig. Fig. 2: The package shelf cover is attached by four clips (arrows). Gently pry up on the cover to release the clips



Click image to see an enlarged view

Fig. Fig. 3: Close up view of the "Christmas tree" type clip used to attach the package shelf cover



Click image to see an enlarged view

Fig. Fig. 4: The rear speakers are attached to the package shelf with four screws (arrows)



Click image to see an enlarged view

Fig. Fig. 5: Carefully lift the speaker from the package shelf. Take care not to damage the speaker's paper cone

The speaker grilles on this vehicle are attached to the package shelf from the underside by four screws. The package shelf must be removed to remove the speaker grilles.

  1. Disconnect the negative battery cable.
  2.  
  3. Remove the rear seat.
  4.  
  5. Remove the package shelf.
  6.  
  7. Remove the four speaker attaching screws.
  8.  

Take care not to damage the speaker cone.

  1. Pull the speaker from the plastic housing.
  2.  
  3. Depress the clip and disconnect the electrical harness.
  4.  

To install:
  1. Connect the speaker electrical harness.
  2.  
  3. Position the speaker, then install and tighten the four speaker attaching screws.
  4.  
  5. Install the package shelf.
  6.  
  7. Install the rear seat.
  8.  
  9. Connect the negative battery cable.
  10.  

 
label.common.footer.alt.autozoneLogo