Nissan_Armada_2004-2005

Sunroof

Print

Power Sunroof



Sunroof Motor
Removal & Installation

When removing the motor be sure that the sunroof is in the fully closed position. Never run the removed motor as a single unit.

  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Position the sunroof in the fully closed position.
  4.  
  5. Disconnect the negative battery cable.
  6.  
  7. Remove the overhead console assembly.
  8.  
  9. Disconnect the harness connector from the motor.
  10.  
  11. Remove the motor mounting screws. Remove the motor from its mounting.
  12.  

To install:


NOTE
Before installing the motor, be sure to place the link and wire assembly in the symmetrical and fully closed position.



Click image to see an enlarged view

Fig. Sunroof motor alignment

  1. Move the motor laterally a little at a time so that the gear is completely engaged into the wire on the sunroof unit and the mounting surface becomes parallel.
  2.  
  3. Secure the retaining bolts.
  4.  
  5. Connect the wiring harness.
  6.  
  7. Continue the installation in the reverse order of the removal procedure.

    Click image to see an enlarged view

    Fig. Overhead console and related components (part one)



    Click image to see an enlarged view

    Fig. Overhead console and related components (part two)

  8.  

Sunroof Diagnosis & Testing


Click image to see an enlarged view

Fig. Power sunroof components and harness connector locations



Click image to see an enlarged view

Fig. Power sunroof wiring schematic

 
label.common.footer.alt.autozoneLogo