Nissan_Armada_2004-2005

Removal & Installation

Print



Click image to see an enlarged view

Fig. Front halfshaft

  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Remove or disconnect the following:

    Wheel
     
    Engine splash guard
     
    Cotter pin and halfshaft nut
     
    Halfshaft from front differential
     
    Halfshaft from hub and bearing assembly
     

  4.  

To install:

  1. Install or connect the following:

    Halfshaft into hub
     
    Halfshaft into front differential
     
    Halfshaft nut and tighten to 101 ft. lbs. and replace cotter pin
     
    Engine splash guard
     
    Wheel
     

  2.  

  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Remove or disconnect the following:

    Wheel
     
    Stabilizer bar clamp
     
    Cotter pin and driveshaft nut
     
    Bolts from the inside flange of the driveshaft
     

  4.  
  5. Separate the driveshaft from the wheel hub by lightly tapping the end with suitable hammer and wood block.
  6.  
  7. Remove the halfshaft.
    CAUTION
    Do not excessively extend the slide joint.

  8.  

To install:

  1. Install or connect the following:

    Halfshaft
     
    Bolts for the inside flange and tighten to 87 ft. lbs. (118 Nm)
     
    Driveshaft nut and tighten nut to 101 ft. lbs. (137 Nm) and replace cotter pin
     
    Stabilizer bar clamp
     
    Wheel
     

  2.  

 
label.common.footer.alt.autozoneLogo