Nissan_Armada_2004-2005

Wheel Hub & Bearings

Print

Removal & Installation



  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Remove or disconnect the following:

    Wheel
     
    Brake caliper without disconnecting the hydraulic lines, and reposition aside with wire
     
    Brake rotor
     
    Cotter pin and nut from driveshaft
     
    Driveshaft
     
    Wheel hub and bearing assembly bolts
     

  4.  
  5. Pulling out the wheel hub and bearing assembly slightly, remove the ABS sensor.
  6.  
  7. Remove the wheel hub and bearing assembly.

    Click image to see an enlarged view

    Fig. Rear hub/bearing assembly

  8.  

To install:

  1. Install or connect the following:

    ABS sensor
     
    Wheel hub and bearing assembly, using new bolts and tighten to 111 ft. lbs. (150 Nm)
     
    Driveshaft
     
    Lock nut and tighten to 101 ft. lbs. (137 Nm) and new cotter pin
     
    Brake rotor
     
    Brake caliper
     
    Wheel
     

  2.  

 
label.common.footer.alt.autozoneLogo