Nissan Car 350Z & Maxima 1999-06

Removal & Installation

Print



Click image to see an enlarged view

Fig. Exploded view of blower and cooling unit



Click image to see an enlarged view

Fig. Removing blower and cooling unit

  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Discharge the A/C system.
  4.  
  5. Disconnect or remove the following:
    NOTE
    Cap the A/C lines to prevent moisture from entering the system.



    Negative battery cable.
     
    Two refrigerant lines from the engine compartment
     



    Glove box and mating trim
     
    Thermal amp connector
     
    Intake sensor connector
     
    Fan control amp, blower motor connector
     
    Blower motor and cooling unit
     
    Separate the blower and cooling unit case, remove evaporator
     
    Three bolts and motor from blower case
     

  6.  
  7. To install, reverse removal procedure.
  8.  
  9. Recharge A/C system.
  10.  

  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Disconnect or remove the following:

    Negative battery cable.
     
    Glove box assembly
     
    Center console side cover
     
    ECM
     
    Blower motor, intake door motor, fan control amp connector
     
    Main harness from the top of the blower unit
     
    Two bolts and one screw from the blower unit
     
    Blower unit
     

  4.  
  5. To install, reverse removal procedure.
  6.  



Click image to see an enlarged view

Fig. Removing blower unit



Click image to see an enlarged view

Fig. Exploded view of blower motor and components



Click image to see an enlarged view

Fig. Removing blower motor

  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Disconnect or remove the following:
    CAUTION
    Move blower unit rightward and remove location pin (1 part) and joint. Then remove blower unit downward.



    Negative battery cable.
     
    Lower instrument passenger panel
     
    ECM with bracket
     
    Intake door motor connector and blower motor connector
     



    Mounting bolts and screws then blower unit
     
    Blower motor mounting screws then blower motor
     

  4.  
  5. To install, reverse removal procedure.
  6.  

 
label.common.footer.alt.autozoneLogo