Nissan Car 350Z & Maxima 1999-06

Fuel Rail (Supply Manifold) & Injectors

Print

Removal & Installation



  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Relieve the fuel system pressure
  4.  
  5. Remove or disconnect the following:

    Negative battery cable
     
    Intake manifold collector
     
    Vacuum hose from the pressure regulator
     
    Fuel hoses from the rail
     
    Injector electrical connectors
     
    Fuel rail bolts
     

  6.  
  7. To remove the fuel injector from the fuel rail, expand and remove the clips securing the injectors and press the fuel injector out from the fuel rail. Discard the O-rings.
  8.  

To install:

  1. Apply a thin coat of engine oil to the new O-rings, install them on the injectors, then press the injector into the fuel rail.
  2.  
  3. Install or connect the following:

    New injector retaining clips
     
    New injector gaskets onto the manifold
     
    Fuel rail assembly to the engine
     
    Fuel rail-to-cylinder head bolts and torque the bolts to 84-96 inch lbs. (9.3-10.8 Nm). Then tighten them again to 16-19 ft. lbs. (21-26 Nm).
     
    Fuel lines to the rail assembly
     
    Vacuum hose to the fuel pressure regulator
     
    Electrical connectors to the fuel injectors
     
    Intake manifold collector
     
    Negative battery cable.
     

  4.  
  5. Start the engine and check for leaks.
  6.  

  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Relieve the fuel system pressure
  4.  
  5. Remove or disconnect the following:

    Negative battery cable
     
    Engine cover
     
    Fuel feed hose and damper
     
    Under vehicle fuel line quick connectors
     
    Upper and lower intake manifold collectors
     
    Fuel injector harness connectors
     
    Fuel rail mounting bolts in reverse of the tightening sequence
     
    Intake manifold spacers
     

  6.  
  7. To remove the fuel injector from the fuel rail, expand and remove the clips securing the injectors and press the fuel injector out from the fuel rail. Discard the O-rings.
  8.  

To install:

Click image to see an enlarged view

Fig. Fuel rail tightening sequence-350Z


NOTE
Upper and lower O-rings are different. The Blue rings go on the fuel tube side and the Brown rings go on the nozzle side.

  1. Apply a thin coat of engine oil to the new O-rings, install them on the injectors, then press the injector into the fuel rail.
  2.  
  3. Install or connect the following:

    New injector retaining clips
     
    Intake manifold spacers
     
    Fuel rail mounting bolts in sequence and tighten to 8 ft. lbs. (11 Nm), then to 16-19 ft. lbs. (21-27 Nm).
     
    Fuel injector harness connectors
     
    Upper and lower intake manifold collectors
     
    Under vehicle fuel line quick connectors
     
    Fuel feed hose and damper
     
    Engine cover
     
    Negative battery cable
     

  4.  
  5. Start the engine and check for leaks.
  6.  

 
label.common.footer.alt.autozoneLogo