Nissan Car Altima & Sentra 1999-06

Instrument Panel

Imprimir

Removal & Installation



Altima
  1. Remove the instrument panel by removing or disconnecting the following:

    Kick plate and dash side finisher on the driver-s side
     
    2 lower panel-to-instrument panel screws and the lower panel on the driver-s side
     
    2 lower reinforcement panel-to-instrument panel screws and the lower reinforcement panel
     
    6 steering column cover screws, the covers, the spiral cable and combination switch
     
    2 cluster lid -A- screws and the cluster lid -A-
     
    3 combination meter screws, disconnect the electrical harness connector and remove the combination meter
     
    Switch panel
     
    Instrument panel lower covers
     
    Snap out the transmission shifter finisher (boot)
     
    4 cluster lid -C- screws and the cluster lid -C-
     
    4 audio and deck pocket-to-instrument panel screws and the audio and deck pocket
     
    5 center console screws and the center console
     
    2 center instrument panel screws and the center panel
     
    front defroster grilles
     
    Front pillar garnish
     
    Instrument panel 3 nuts/4 screws and the instrument panel
     
    8 instrument stay assembly nuts and the stay
     
    Steering member assembly 5 nuts/1 bolt and the steering member
     

  2.  

To install:

  1. Install the instrument panel by installing or connecting the following:

    Steering member assembly and the steering member 5 nuts/1 bolt
     
    Instrument stay assembly and the 8 stay nuts
     
    Instrument panel and the instrument panel 3 nuts/4 screws
     
    Front pillar garnish
     
    Front defroster grilles
     
    Center instrument panel and the 2 center panel screws
     
    Center console and the 5 center console screws
     
    Audio and deck pocket and the 4 audio and deck pocket-to-instrument panel screws
     
    Cluster lid -C- and the 4 cluster lid -C- screws
     
    Snap in the transmission shifter finisher (boot)
     
    Instrument panel lower covers
     
    Switch panel
     
    Combination meter, connect the electrical harness connector and install the 3 combination meter screws
     
    Cluster lid -A- and the 2 cluster lid -A- screw
     
    Combination switch, the spiral cable, the covers and the 6 steering column cover screws
     
    Lower reinforcement panel and the 2 lower reinforcement panel-to-instrument panel screws