Nissan Frontier, Xterra 1998-05

Rear Main Seal

Print

Removal & Installation



  1. Before servicing the vehicle, refer to the Precautions section.
  2.  
  3. Remove or disconnect the following:

    Transmission
     
    Flywheel
     
    Rear main seal
     

  4.  

To install:

  1. Install the seal so that it is flush with the retainer housing.
  2.  
  3. Install or connect the following:

    Flywheel. Tighten the bolts to 61-69 ft. lbs. (83-93 Nm).
     
    Transmission
     

  4.  

  1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
  2.  
  3. Remove or disconnect the following:

    Transmission
     
    Flywheel
     
    Rear main seal
     

  4.  

To install:

  1. Install the seal so that it is flush with the retainer housing.
  2.  
  3. Install or connect the following:

    Flywheel. Tighten the bolts to 61-69 ft. lbs. (83-93 Nm).
     
    Transmission
     

  4.  

  1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
  2.  
  3. Remove or disconnect the following:

    Transmission
     
    Flywheel
     
    Rear main seal
     

  4.  

To install:

  1. Install the seal so that it is flush with the retainer housing.
  2.  
  3. Install or connect the following:

    Flywheel. Tighten the bolts to 61-69 ft. lbs. (83-93 Nm).
     
    Transmission
     

  4.  

  1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
  2.  
  3. Remove or disconnect the following:

    Transmission
     
    Flywheel
     
    Rear main seal
     

  4.  

To install:

  1. Install the seal so that it is flush with the retainer housing.
  2.  
  3. Install or connect the following:

    Flywheel. Tighten the bolts to 61-69 ft. lbs. (83-93 Nm).
     
    Transmission
     

  4.  

  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Remove or disconnect the following:

    Transmission
     
    Flywheel
     
    Clutch, if equipped
     
    Rear main seal
     

  4.  

To install:

  1. Install the seal so that it is flush with the retainer housing.
  2.  
  3. Install or connect the following:

    Flywheel. Tighten the bolts to specification.
     
    Transmission
     

  4.  

 
label.common.footer.alt.autozoneLogo