Nissan Frontier, Xterra 1998-05

Removal & Installation

Imprimir

  1. Before servicing the vehicle, refer to the Precautions section.
  2.  
  3. Remove or disconnect the following:

    Front wheel
     
    Wheel speed sensor, if equipped
     
    Locking hub or drive flange
     
    Snapring
     
    Spindle washer
     
    Thrust washer
     
    Inner CV-joint bolts
     
    Axle halfshaft. Separate the stub shaft from the spindle by tapping with a plastic hammer.
     

  4.  

To install:

  1. Install or connect the following:

    Axle halfshaft. Guide the stub shaft into the spindle and tighten the inner CV-joint bolts to 25-33 ft. lbs. (34-44 Nm).
     
    Thrust washer
     
    Spindle washer
     
    Snapring
     
    Locking hub or drive flange
     
    Wheel speed sensor, if equipped
     
    Front wheel
     

  2.  

  1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
  2.  
  3. Remove or disconnect the following:

    Front wheel
     
    Wheel speed sensor, if equipped
     
    Locking hub or drive flange
     
    Snapring
     
    Spindle washer
     
    Thrust washer
     
    Inner CV-joint bolts
     
    Axle halfshaft. Separate the stub shaft from the spindle by tapping with a plastic hammer.
     

  4.  

To install:

  1. Install or connect the following:

    Axle halfshaft. Guide the stub shaft into the spindle and tighten the inner CV-joint bolts to 25-33 ft. lbs. (34-44 Nm).
     
    Thrust washer
     
    Spindle washer
     
    Snapring
     
    Locking hub or drive flange
     
    Wheel speed sensor, if equipped
     
    Front wheel
     

  2.  

  1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
  2.  
  3. Remove or disconnect the following: