STARTING THE ENGINE
Now that the engine is installed and every wire and hose is properly connected, go back and double check that all coolant and vacuum hoses are connected. Check that you oil drain plug is installed and properly tightened. If not already done, install a new oil filter onto the engine. Fill the crankcase with the proper amount and grade of engine oil. Fill the cooling system with a 50/50 mixture of coolant/water.
- Connect the vehicle battery.
- Start the engine. Keep your eye on your oil pressure indicator; if it does not indicate oil pressure within 10 seconds of starting, turn the vehicle off.
- Confirm that there are no fluid leaks (oil or other).
- Allow the engine to reach normal operating temperature (the upper radiator hose will be hot to the touch).
- If necessary, set the ignition timing.
- Install any remaining components such as the air cleaner (if removed for ignition timing) or body panels which were removed.
BREAKING IT IN
Make the first miles on the new engine, easy ones. Vary the speed but do not accelerate hard. Most importantly, do not lug the engine, and avoid sustained high speeds until at least 100 miles. Check the engine oil and coolant levels frequently. Expect the engine to use a little oil until the rings seat. Change the oil and filter at 500 miles, 1500 miles, then every 3000 miles past that.