REMOVAL & INSTALLATION
See Figures 1, 2, 3, 4, 5, 6, 7 and 8
Fig. Fig. 1: There is a fuse on the back of the radio that can only be accessed by removing the radio
Fig. Fig. 2: Unclip the trim panel surrounding the shifter to allow for removal of the fascia surrounding the radio
Fig. Fig. 3: Pull the shift mode switch (automatic models) out of the lower fascia and disconnect it
Fig. Fig. 4: Remove the two screws on the bottom of the fascia ...
Fig. Fig. 5: ... then carefully unclip it by pulling outward
Fig. Fig. 6: Unclip the connectors from the cigarette lighter and set the panel aside
Fig. Fig. 7: Remove the radio retaining screws and slide the radio out of the center console
Fig. Fig. 8: Pull out on the connectors to remove them from the radio
Remove the dash panel trim panel that surrounds the radio.
Remove the screws securing the radio.
Carefully pull the radio from the dash panel.
Label and disconnect the electrical harnesses and antenna wire.
Remove the radio from the vehicle.
Connect the electrical harnesses and antenna wire.
Carefully position the radio in the dash panel.
Install the four radio attaching screws and tighten securely.
Install the trim panel that surrounds the radio.