Nissan Murano 2003-05

Instrument Panel, Pad, and Dashboard

Print

Instrument Panel



Removal & Installation

NOTE
Be sure to disarm the SRS system, prior to working on the vehicle. Turn the ignition switch OFF, disconnect both battery cables and wait at least three minutes before starting any work.



Click image to see an enlarged view

Fig. Instrument panel and related components

  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Disconnect both battery cables.
  4.  
  5. Remove instrument driver lower panel screws.
  6.  
  7. Remove data link connector.
  8.  
  9. Pull to disengage metal clip by removing panel in horizontal direction.
  10.  
  11. Disconnect in-vehicle sensor and each electrical parts.
  12.  
  13. Remove bolts, and remove hood lock opener.
  14.  
  15. Remove tilt lever knob screws.
  16.  
  17. Remove the knob by picking it up and pulling it out. Using a remover, ply and remove tilt lever mask.
  18.  
  19. Remove steering column cover screws.
  20.  
  21. Disengage the tab, and remove steering column cover. After removing combination meter screws, remove harness connector.
  22.  
  23. Using a remover, pry and remove side ventilator assembly (left/right).
  24.  
  25. Disconnect aiming switch harness connector and VDC switch harness connector only left side.
  26.  
  27. Insert a remover into lower space of instrument side finisher (left/right) and remove by lifting.
  28.  
  29. Remove screws and glove box striker, disconnect connectors, and remove instrument passenger lower panel assembly.
  30.  
  31. Detach the damper from glove box right side.
  32.  
  33. Remove glove box pins, and remove glove box.
  34.  
  35. Insert a remover into lower space of center ventilator and remove by lifting.
  36.  
  37. Insert a remover into upper space of center ventilator and the upper clip is removed.
  38.  
  39. Remove screws. Disconnect harness connector, and remove tweeter with right and left part.
  40.  
  41. Insert a remover into front space of instrument stay cover (left/right) and detach.
  42.  
  43. Disconnect the left side harness connector only.
  44.  
  45. Remove cluster lid screws.
  46.  
  47. Disconnect A/C and AV harness connectors, and remove cluster lid C.
  48.  
  49. Remove display unit screws.
  50.  
  51. Disconnect harness connector and remove display.
  52.  
  53. Using a remover and disengage the ignition key finisher metal clips
  54.  
  55. Disconnect harness connector.
  56.  
  57. Using a remover, pry and remove instrument mask.
  58.  
  59. Disconnect harness connector.
  60.  
  61. Remove screw. Disengage the metal clip and remove instrument driver upper panel.
  62.  
  63. Remove the bolt and screws and remove the front passenger air bag module.
  64.  
  65. Disconnect metal clips, then remove instrument passenger upper panel.
  66.  
  67. Disconnect harness connector.
  68.  
  69. Pull to inside of vehicle, disconnect metal clips and remove front pillar garnish.
  70.  
  71. Remove bolts and screws, and remove instrument panel from passenger door opening portion.
  72.  
  73. Tweeter and sensor harness clip are removed from the duct.
  74.  
  75. Remove instrument panel assembly.
  76.  

To install:

  1. Installation is the reverse of removal. Note the following points:
  2.  

 
label.common.footer.alt.autozoneLogo