Nissan Pick-ups and Pathfinder 1970-1988

Battery

Print

Refer to General Information & Maintenance for details on battery maintenance.

REMOVAL & INSTALLATION



  1. Disconnect the negative battery cable from the terminal, then disconnect the positive cable. Special pullers are available to remove post clamps.
  2.  

To avoid sparks, always disconnect the negative cable first and reconnect it last.

  1. Unscrew and remove the battery hold-down clamp.
  2.  
  3. Remove the battery, being careful not to spill any of the acid.
  4.  

Spilled acid can be neutralized with a baking soda and water solution. If you somehow get acid into your eyes, flush it out with lots of clean water and get to a doctor as quickly as possible.

To install:
  1. Clean the battery terminals thoroughly before reinstalling or when installing a new one.
  2.  
  3. Clean the cable clamps using the special tools or a wire brush, both inside and out.
  4.  
  5. Install the battery, and the hold-down clamp. Connect the positive and then the negative cable. Do not hammer post clamps into place. The terminals should be coated with grease to prevent corrosion.
  6.  


CAUTION
Make absolutely sure that the battery is connected properly before you turn on the ignition switch. Reversed polarity can burn out our alternator and regulator in a matter of seconds.

 
label.common.footer.alt.autozoneLogo