See Figures 1 and 2
The valve spring squareness, length and tension should be checked while the valve train is disassembled. Place each valve spring on a flat surface next to a steel square. Measure the length of the spring, and rotate it against the edge of the square to measure distortion. If spring length varies (by comparison) by more than 0.062 in. (1.6mm) or if distortion exceeds 0.062 in. (1.6mm), replace the spring.
Spring tension must be checked on a spring tester. Springs used on most engines should be within one pound of each other when tested at their specified installed heights.