LINKAGE AND SHIFTER
All models utilize a floor-mounted shifter and an internally-mounted shift linkage. No external adjustments are either necessary or possible.
CLUTCH INTERLOCK SWITCH
See Figure 1
Adjust the clearance (C) between the clutch pedal stopper bracket and the threaded end of the clutch switch while fully depressing the clutch pedal. There is a locknut on the back side of the switch mounting bracket, loosen it and then rotate the nut on the front of the bracket to move the switch assembly in or out. Clearance should be 0.012-0.039 in. (0.3-1.0mm). Tighten the locknut to 9-11 ft. lbs. (12-15 Nm).