Nissan Quest 2001-02 and 2004-06

Stabilizer Bar (Sway Bar) & Links

Print

Removal & Installation





Click image to see an enlarged view

Fig. Removing stabilizer bar bolts

  1. Before servicing the vehicle, refer to the precautions section.
  2.  
  3. Remove the stabilizer bar.
  4.  
  5. To install, reverse removal procedure.
    NOTE
    When installing stabilizer, make sure that the paint marks are facing toward the outside of the vehicle.

  6.  



Click image to see an enlarged view

Fig. Exploded view of stabilizer bar and components

  1. Before servicing the vehicle, refer to the precautions section.
  2.  
  3. Raise and safely support the vehicle.
  4.  
  5. Disconnect or remove the following:
    NOTE
    Prevent the connecting rod from turning by inserting a hex wrench into the end of the ball stud, then remove nut.



    Wheel and tire
     
    Steering gear bolts on the lower side
     



    Connecting rod end at the stabilizer bar using power tool
     
    Two stabilizer bar clamps from the front suspension member
     
    Stabilizer bar by withdrawing from side and two stabilizer bushings as necessary
     

  6.  
  7. To install, reverse removal procedure.
  8.  
  9. When installing stabilizer bar, make sure that the stabilizer clamps are facing in the correct direction as shown in illustration.
  10.  
  11. Make sure that slit in stabilizer bushing is facing the front of the vehicle.
  12.  
  13. Lubricate the inner and outer surfaces of the stabilizer bushing using a silicone lubricant.

    Click image to see an enlarged view

    Fig. Installing stabilizer bar clamps

  14.  

 
label.common.footer.alt.autozoneLogo